The LDS-01 is a 2D laser scanner capable of sensing 360 degrees that collects a set of data around the robot to use for SLAM (Simultaneous Localization and Mapping). It supports USB interface and is ...
This LiPo battery is intended for Engineer Kits.
PCM is incorporated to protect the battery from overcharge, discharge, and excessive current.
Can be recharged with LBC-010 Battery Charger.
- Used to control the Dynamixel using the Arduino board.
- Mounts above the Arduino board and can be used with the OpenCR controller
- Various shields can be stacked on the Dynamixel Shield
U2D2 is a small size USB communication converter that enables to control and to operate the DYNAMIXEL with the PC.
It is smaller than the previous model and has mount holes to make it easier to ...
The U2D2 Power Hub Board combines with the U2D2 to supply a variety of external power sources to DYNAMIXELs.
The board is capable of supplying power to all DYNAMIXELs with the SMPS port, terminal ...
BT-210 is a device that enables serial communication (UART) via Bluetooth communication.
BT-210 has a case that protects the circuits and a connector-type cable to connect the device onto the robot.
The BT-210 is a product that uses Bluetooth communication to enable serial communication (UART).
The BT-210 covers the circuit with a case to protect it, and it uses a connector-type cable to ...
BT-410 is a device that enables serial communication (UART) via Bluetooth communication.
BT-410 has a case that protects the circuits and a connector-type cable that is used to connect the device ...
This motor is used with the controller in the ROBOTIS DREAM can be controlled by controlling the port.
By controlling the direction and speed of the rotation, this motor can be used to turn the ...
CM-550 is a controller that includes a MCU, DYNAMIXEL TTL Communication board, BLE Slave communication module, Gyro Accelerometer, Temperature sensor, Buzzer, RGB LED, Sensor ports, MIC, etc.
-CM-150 controller is used with ROBOTIS DREAM.
-Various DREAM parts (geared motor, servo motor, touch sensor, LED module, IR sensor, etc.) can be connected to CM-150.
