.
BT-210 Set
Description
Features
The BT-210 is a product that uses Bluetooth communication to enable serial communication (UART).
The BT-210 covers the circuit with a case to protect it, and it uses a connector-type cable to install on a robot and RC-100B.
You can control your robot without any problems even when the infrared control condition is not optimal such as in a robot competition.
The SLAVE module can be used when controlling the robot from a device that supports Bluetooth communication such as a smartphone, tablet PC or notebook.
Package Components
| BT-210 (120mm cable included) | 2 |
|---|
H/W Specifications
| Weight | 4.51g |
|---|---|
| Size | 18mm x 30mm x 9.1mm |
| Bluetooth | Bluetooth Specification 2.1 Support |
| Effective Communication Distance | 10m |
| Frequency | 2.4 GHz ISM Band |
| Bandwidth | MAX 250kbps |
| Default Baud rate | 57600bps |
| Sensitivity | -81dBm (Typical) |
| Transmit Power | 4dBm(Typical) |
| Bluetooth Profile Support | SPP (Serial Port Profile) |
| Operational Voltage | 3.3V |
| Consumed Current | 48mA (Max) |
| Operating Temperature | -40℃ ~ 85℃ |
| Baud rate Range | 1,200bps ~ 400,000bps |
| Antenna | Chip Antenna |
| Interface | UART (3.3V Level) |
| Conducted Net Power | -6 ~ 4dBm (Class 2) |
Compatible Products
Controller : CM-530 (Wireless control, wireless download possible)
CM-510, CM-700 (Wireless control possible (firmware update required))
Remote Control : RC-100B
Caution
The MASTER module and the SLAVE module are divided – MASTER module for the transmitter; SLAVE module for the robot.
When first released and purchased, the two modules are paired so there is no need for a separate ID setting procedure. If either of the components is lost, you will have to purchase the BT-210 (Product code 902-0076-000) for pairing.
Directions for pairing can be found in our e-Manual.
Click to refer to directions for pairing
The initial Pin Code when released from factory is 0000. Use this when connecting to the Bluetooth device(SLAVE). When a change is needed, please refer to the link above. However, OpenCM-9.04-A or C type controller is required.
Installation Not Supported
-Remote Control : RC-100, RC-100A
-Controller : CM-100, CM-5, CM-2+
